Filter
Top Products
18
Base ringer melody & volume
1. Press
PROG
during standby and press
or until you see
flashing.
2. Press
OK
to select.
3. Press to listen to and select from the 5 melodies.
4. Press
OK
to confirm your selection and you will be prompted to
volume Setting.
5. Press
to listen to and select from the different volume
levels.
6. Press
OK
to confirm your selection.
You have the option to turn off the base ringer. You cannot program the
base ringer if the handset has lost the link with the base. UNAVAIL will
be displayed. Re-establish the link and try again.
Recall duration
When you are talking on the phone, pressing
will send a flash signal.
Recall settings are; Australia (Recall 1)100ms and New Zealand (Recall
2) 600ms. You should not need to change these settings.
Press
PROG
during standby and press
until you see
flashing.
1. Press
OK
to select. The current duration is now displayed.
2. Press 1 or 2 directly or press to select.
3. Press
OK
to confirm.
Register
Each handset can register to one base at a time only. The current base
will be deregistered when a new base is registered.
Each base can register up to 4 handsets.
1. Press
PROG
during standby and press
or until you see
icon flashing.
2. Press
OK
to select.
3. Before you enter the PIN, press and hold
on the base for 2
seconds until a registration tone is emitted. The base is now in the
registration mode. (If the base is full and cannot add any more
handsets, it will emit a reject tone instead. See the section of
Deregister to delete a currently registered handset.)