Filter
Top Products
15CORDLESS hANDSET OpERATION
Note:
When the keypad is locked, [ ] key and [ INT ] key can
be used to answer an external or intercom call.
Registration
Register new handsets on the eco50 base
The handsets which come in the same pack are already
registered to the base. If you buy new handsets. You need
to register them before use.
1. Charge the batteries (for 15 hours).
2. Register the handset (to the base unit).
Each base can register up to 5 handsets.
During standby mode,
1. Press and hold the [
\ ] key for 3 seconds until both
the [ ] and [ ] icons flash, then press and hold the
[ ] key for 3 seconds. The following will appear on
the display.
2. Press 1 and the handset begins to search for the base.
3. Enter the base pin code (0000). If the pin is wrong, the
handset will restart searching for the base.
4. When the handset is registered, it will show “
HS”
followed by the handset number.
Note:
If the base is full and cannot add any more handsets, you
will hear a tone. See the next section to remove a handset.
Remove handsets
During standby mode,
1. Press and hold the [
\ ] key for 3 seconds, then press
and hold the [ ] key for 3 seconds.
2. Enter the default value 0000. If the pin is wrong, the
handset will go back to standby.
3. Press the numeric keys (1-4) to enter the handset number
you want to remove.
4. The unit will go back to standby if the removal is
successful.
Note:
You can only remove other handsets in your system but
you are not able to remove the handset you are using.