Filter
Top Products
P0908515 Issue 01 Enterprise Edge M7410 User Guide
Handset Overview
You must rotate the base antenna in a vertical position when you are using the
handset.
The Enterprise Edge M7410 telephone is equipped with an Automatic Channel
Selection feature. The handset display shows a Scanning message when the
Enterprise Edge M7410 searches for a new channel.
If interference is detected, the handset display shows an Interference message
and the Enterprise Edge M7410 automatically searches for a new channel with no
interference.
Handset Signal strength
You can monitor the handset signal strength while moving to different locations.
The following icons appear on the handset display.
When you move too far from the base, the following occurs on the handset:
• the signal strength icon flashes.
• Scanning and Out of range messages appear.
• A warning tone sounds every 15 seconds.
Note: To disable the tone, press OK on the handset.
If the signal strength is weak, move back into range to stop the handset display
messages and warning tones.
If you go completely out of range during an active call, the call is automatically
placed on hold. Refer to Holding calls on page 31 for more information.
Retrieve a held call by selecting the flashing line button when you are back in range.
Full strength
Half strength
Low strength
Out of range
Icon flashes on the
display.
9