Filter
Top Products
i2022 ISDN Teleset
ii
Mandatory Customer Information
Federal Communications Commission (FCC) Requirements
This equipment complies with Part 68 of the FCC Rules. The FCC registration information is located on a label affixed to the bottom of
the Teleset. If requested, you must provide the telephone company with the following information: Facilities interface Code (FIC) 02IS5,
Service Order Code 6.0Y, and Registered Jack RJ-49C
*.
When the i2022 Teleset is equipped with an S Interface Module, FCC regulations require an FCC Registered NT1 device be used when
connecting this Teleset to the network.
If your telephone equipment causes harm to the network, the telephone company may discontinue your service temporarily. If possible,
they will notify you in advance. But if advance notice is not practical, you will be informed of your right to file a complaint with the FCC.
Your telephone company may change its facilities, equipment, operations or procedures that could affect the proper functioning of your
equipment. If they do, you will be notified in advance to give you an opportunity to maintain uninterrupted telephone service.
If you experience trouble with this telephone equipment, please contact your telephone equipment distributor for repairs. The telephone
company may ask that you disconnect this equipment from the network until the problem has been corrected.
Federal Communications Commission (FCC) Requirements, Part 15
This equipment has been tested and found to comply with the limits for a Class B digital device as specified in Part 15 of the FCC rules.
These rules are designed to provide against radio-frequency interference in a residential installation. However, there is no guarantee
that harmful interference will not occur in a particular installation.
* The RJ-49C refers to the network jack provided by the telephone company. This is the jack that interfaces to the FCC registered NT1
device when the i2022 is equipped with the S Module, not the Line In jack on the S Interface Module.
Trademark Acknowledgment
5ESS is a registered trademark of Lucent Technologies.
DMS-100 is a registered trademark of NORTEL, Inc.
EWSD and Siemens are registered trademarks of Siemens Information and Communication Networks
GTD-5 is a registered trademark of AG Communications Systems
IMPORTANT SAFETY INSTRUCTIONS
When using your telephone equipment, basic safety precautions should be followed to reduce the risk of fire, electric shock, and
personal injury.
Read and follow all instructions.
Follow all warnings and instructions marked on the product.
Disconnect the telephone from the telephone line before cleaning. Do not use aerosol or liquid cleaners. Use a damp cloth only.
Do not use this equipment near water, for example, a bathtub, a pool, sink or laundry tub.
Do not use this equipment in a wet basement.
If this equipment accidentally falls into water, do not retrieve it until you have disconnected it from the telephone line.
Disconnect it at the wall jack only.
This product should not be placed near or over a radiator or heat register.
Do not place this product in such a way as to cause the cord to be a tripping hazard.
To avoid the risk of electrical shock, never push objects of any kind through slots or openings in the product.
Do not disassemble this product. Opening the product can expose hazardous voltage, which may cause an electrical shock.
Unplug this equipment and refer to a qualified technician if:
1. The cord is damaged or frayed.
2. Liquid has been spilled on this equipment.
3. This equipment has been exposed to water or rain.
4. If this equipment does not operate properly.
5. If this equipment has been dropped or appears damaged.
Avoid using this equipment during an electrical storm.
Do not use this equipment to report a gas leak if it is in the vicinity of the leak.
This product should not be placed on an unstable table, stand or cart. The product may fall, causing serious damage to it.
Do not overload wall outlets and extension cords as this can result in risk of fire and electrical shock.
This product should only be operated from the type of power source indicated on the label. If you are not sure of the type of
power supplied to your home, consult your dealer or local power company.
SAVE THESE INSTRUCTIONS