Filter
Top Products
i2022 ISDN Teleset
11
INSTALLING THE LOGO PLATE
ASSEMBLING THE i2022
Inserting and removing the modules
The i2022 Teleset requires either an S Interface module or a U Interface Module. There are also optional Data Modules
available. There are two slots on the bottom of the i2022. The S and U modules fit in the left slot (as viewed from the rear
with the i2022 upside down) and the Data Modules fit in the right slot. Different size connectors prevent the modules from
being inserted into the wrong slot. Each module is locked into place by means of a slide lock.
To remove the modules:
1. Disconnect any cords that are attached to the Teleset.
2. Disconnect and remove the handset and headset.
3. Remove the Wall-Mount/Desk Stand Base if attached.
4. Return the display to the flush (down) position.
5. Place the i2022 upside down with the rear of the Teleset facing you.
6. Unlock the module by sliding the lock away from the module, towards the side of the Teleset.
7. Slide the module to the rear of the Teleset using the finger pad on the module and remove the module.
To insert the modules:
1. Disconnect any cords that are attached to the Teleset.
2. Disconnect and remove the handset and headset.
3. Remove the Wall-Mount/Desk Stand Base if attached.
4. Return the display to the flush (down) position.
5. Place the i2022 upside down with the rear of the Teleset facing you.
6. Make sure the connector on the module matches the connector on the bottom of the Teleset.
7. Insert the module, finger pad up, into the guide slots on the bottom of the Teleset.
8. Push the module forward until it is properly seated into the connector.
9. Lock the module by sliding the lock towards the module. The slide lock will not engage unless the module is firmly seated.
10. Re-assemble the Teleset.