Filter
Top Products
Page 6 NDA-30130 Revision 1
INSTALLATION & SET-UP Voicemail Disconnect Installation & Operation Manual
MAT Assignments
This manual assumes that data settings that affect the operation of all OAI software
on a system-wide basis have already been assigned on the NEAX Maintenance
Administration Terminal (MAT). Such settings include system index values and
assignment of Interface I/O Port Data in the Interface Processor (IP). For more
information about these system data settings and the MAT commands described
below for Voicemail Disconnect, refer to the OAI Module Installation Manual for
the NEAX2400 IMS, the NEAX2400 IMS Command Manual, the NEAX2400 IMS
Job Specification Manual, and the NEAX2400 IMS Programming Manual.
Using the AOKC command, assign the MSF facility and its Op-Code to one of the
14 OAI Key Codes in the MAT. Each of these OAI Key Codes corresponds to an
AKYD Function Key Index (FKI) value that is then assigned to the specific D
term
function key. This process is illustrated below.
Figure 1-1 OAI Function Key Assignments
A knowledge of the D
term
stations in the NEAX system and which ones will be set
up to access Voicemail Disconnect is needed to use the necessary MAT commands.
Continue to the next section to set-up these various MAT assignments...
APM
Application
Configuration
Designation of
Facility
(Type)
and its Op-
Code
for Use by
Application
MAT
AOKC
Command
Assignment of
an OAI
Key Code
(between 1
and 14)
to the Same
Facility Type
and Op-
Code
MAT
AKYD
Command
Assignment of
Corresponding MAT
Function Key Index to
a
specific D
term
Function Key
. . . . .
. . . . .
. . .
. . .
PBX Correspondence of
AOKC AKYD
OAI Function
Key Codes
Key Indices
1 < . . . .> 34
2 < . . . .> 35
3 < . . . .> 36
4 < . . . .> 37
5 < . . . .> 38
6 < . . . .> 39
7 < . . . .> 40
8 < . . . .> 41
9 < . . . .> 42
10 < . . . .> 43
11 < . . . .> 44
12 < . . . .> 45
13 < . . . .> 46
14 < . . . .> 47