Mitel SUPERSET 4025 Telephone User Manual


 
4
Using a Headset
Note: Your system administrator may have enabled full-time headset operation
on your telephone. Phones with full-time headset operation enabled must be
operated only with headsets.
A headset can be used either in regular answer mode or with the Auto Answer
feature programmed.
Most headsets are installed using the same jack that the handset plugs into.
MITEL’s Headset with Feature Control Switch plugs into the dedicated headset
jack (the jack nearest the front of the telephone).
To Install a Headset (no feature control switch)
To install the headset for your use, perform the following tasks:
1. When the telephone is not in use, lift the handset from the cradle and
carefully turn the telephone upside down.
2. Unplug the handset cord where it connects to the telephone.
3. Plug in the headset cord in the same place.
4. Store your handset in a safe place.
To return to handset operation, perform the following tasks:
1. When the telephone is not in use, lift the handset from the cradle and
carefully turn the telephone upside down.
2. Unplug the headset cord where it connects to the telephone.
3. Plug in the handset cord in the same place.
4. Set the telephone upright and return the handset to the cradle.
5. Store your headset in a safe place.