Filter
Top Products
-16-
Call Park
The Call Park feature allows you to place a call in a special hold state. You,
or someone else, can then retrieve the call from any extension in the
system.
After parking the call, the system can automatically connect you to paging
equipment so that you can announce the call to the requested party.
To park an active call:
1. Do one of the following:
Press the Call Park feature key (must be programmed)
Press TRANS/CONF, and then dial *7#.
The display shows PARKED@, followed by the park destination and
parking spot index (if applicable). Example: PARKED@ 1234 @ 02.
2. Dial the directory number on which to park the call (not required if the
number is programmed to the Call Park feature key).
3. To inform a user that a parked call is waiting, do one of the following:
If automatic paging is enabled, announce the call and the park
retrieve digits shown on the display.
If automatic paging is disabled, dial **9, followed by the Pa
g
in
g
zone
number (if required). Then, announce the call and park retrieve digits
shown on the display.
To retrieve a parked call:
1. Do one of the following:
Dial *8#.
Press the Call Park - Retrieve feature key (must be programmed).
2. Dial the directory number on which the call is parked (not required if the
number is programmed to the Call Park feature key).
3. If there are multiple calls parked on the number, dial the two-digit index
number to retrieve a specific call, or # to retrieve the lon
g
est parked call.