Filter
Top Products
IP8815 Nortel IP Phone
User Guide
14 Jan. ‘09
o Press the Setting ( ) button.
o Dial 3, or move the cursor to 3.Phone Settings using the Previous-Next softkeys and press the
OK softkey.
o Dial 2, or move the cursor to 2.Ring Setting using the Previous-Next softkeys and press the OK
softkey.
o Dial 1, or move the cursor to 1.Default Ring Type using the
Previous-Next softkeys and press the OK softkey. An asterisk,
», displays in front of the current setting.
o Select the ring type using the Next softkey. Press the Play
softkey to hear the selected tone.
o Press the OK softkey to save the selected the ring type.
o Move to another parameter with the Return button, , and
continue the session or press the Settings ( ) button to exit
the configuration session.
5.2.2. Setting Line Ring Type and Delay
You can assign each line with a different ring type (tone) to distinguish which line is ringing. Selections
for the type include one of up to fourteen tones, “Ringer Off” or “Set to Default”, see section 5.2.1
. Of the
fourteen tones, nine are permanently stored in the memory of the phone and the remaining five must be
downloaded before use. In addition, for each line the ring signal can be immediate or delayed. The delay
is set in 1 second increments from 0 (no delay) to 10 seconds.
To set the ring type for a line:
o Press the Setting ( ) button.
o Dial 3, or move the cursor to 3.Phone Settings using the Previous-Next softkeys and press the
OK softkey.
o Dial 2, or move the cursor to 2.Ring Setting using the Previous-Next softkeys and press the OK
softkey.
o Dial the Line number plus one (2 for Line 1, 3 for Line 2, etc.), or
move the cursor to Line
n
Configuration using the Previous-
Next softkeys and press the OK softkey. The value of
n
is the
Line button number.
o Dial 1, or move the cursor to 1.Ring Type using the Previous-
Next softkeys and press the OK softkey. Note the line number
displays in parenthesis after “Ring Type”.
o Select the ring type using the Next softkey. Press the Play
softkey to hear the selected tone. An asterisk, », displays in
front of the current setting.
o Press the OK softkey to save your entry.
o Move to another parameter with the Return button, , and
continue the session or press the Settings ( ) button to exit
Default Ring Type
*Type 1
Jan 23 08:30
Play Next
OK
Ring Setting
>1.Default Ring Type
2.Line 1 Configuration
Jan 23 08:30
Previous Next
OK
Ring Type (2)
*Set to default
Jan 23 08:30
Play Next
OK
Line 2 Configuration
>1. Ring Type
2. Delayed Ring Timer
Jan 23 08:30
Previous Next
OK
Ring Setting
2.Line 1 Configuration
>3.Line 2 Configuration
Jan 23 08:30
Previous Next
OK