Filter
Top Products
Interference
4/5/6
54
C
SET
Bi
6
Note: The transmission range may
become shorter if the system is
interfered by a stronger radio
frequency from sources of high
voltage electric power or obstacles
like tall buildings. The transmitter
uses low output powered
frequency.
14
Turbo Timer Mode
(Also See Installation Manual)
Turbo Timer Mode keeps the engine running after arriving at you destination for a programmable
time period of 1, 3 or 5 minutes. This allows the system’s time to conveniently cool down the turbo
after you have left the vehicle.
To Activate:
1. While the engine is running, set the emergency brake and place the transmission to "Park".
2. Before turning off the engine, press and release and buttons at the same time. The light
will flash to indicate the remote start has entered turbo charge mode.
3. Remove the “Ignition Key” from the key cylinder. The engine will keep running.
4. Exit and secure the vehicle. The Engine continues running until the pre-programmed time
elapsed.
Turn Off Remote Start
When the engine is running by remote start and you wish to stop the engine from remote start:
1. Press the button twice on the remote transmitter.
2. Move the optional remote start toggle switch to the “OFF” position (if installed).
3. Press the vehicle’s brake pedal, the engine will stop running and the parking lights turn off to
indicate the engine has stopped.
Shut Down Input for Remote Starter
If any of the following conditions exist while the system is operating, the engine will not start or will
shut down immediately:
1. The hood is opened.
2. The brake pedal is pressed.
3. Engine is over reeved (Tachometer Type Only).
4. The pre-programmed run time (5-10-20-30 minutes) has elapsed.
5. Press the button once on the remote transmitter while in remote start mode only.
6. Move the optional remote start enable toggle switch to “OFF” position (if installed).
7. The vehicle refused to start running after 3 unsuccessful attempts.
M11RF-LCD-UM 9/10/04 9:48 AM Page 14