Magnadyne M11RF-LCD Two-Way Radio User Manual


 
Dome Light Supervision
The Security System has a unique feature for using your vehicle’s dome light.
1. Upon disarming the vehicles security system, the interior dome light will remain on
for thirty seconds.
2. If the security system is triggered, the dome light will flash for the same duration
as the horn/siren.
Ignition Controlled Door Locks
If the vehicles door locks have been interfaced with the security system, the system will
automatically lock the vehicle’s doors when the ignition key is turned to the “ON” position and or
unlock the doors when ignition key is turned to the “OFF” position.
Channel 3: Trunk Release Output
Press and hold the button for two seconds to activate the trunk release
(Channel 3 output) and/or any other devices connected.
Channel 4: Timer Control Output
Press and hold the and button at the same time to activate the Channel 4 output.
Channel 4 is user programmable output. You may program the built in timer to send a ground
signal for any time duration from 1 second to 120 seconds.
Channel 5: Timer Control Output
Press and hold the and button at the same time to activate the Channel 5 output. Channel 5
is user programmable output. You may program the built in timer to send a ground signal for any
time duration from 1 second to 120 seconds.
Channel 6: Timer Control Output
Press and hold the and button at the same time to activate the Channel 6 output. Channel 6
is user programmable output. You may program the built in timer to send a ground signal for any
time duration from 1 second to 120 seconds.
Note: These timer outputs (4-6) may be used to turn on the Headlights, Power Windows or Power
Sunroofs (Factory Settings are Momentary Outputs).
11
System Status Check
(Continued)
1. First press the SET button on the transmitter, within 3 seconds press the buttons to
activate outdoor driver paging function. The vehicle will then respond with chirps from the
horn/siren and a melody sound from the LCD transmitter. The icon will then appear on the
LCD transmitter screen.
2. When the windshield knock sensor is activated, the vehicle will then respond with chirps from
the horn/siren and a melody sound from the LCD transmitter. The icon will then appear on
the LCD transmitter screen.
3. A. Turn on the ignition switch or press the button to arm the system.
B. Press the button to disarm the system. This will then exit this function.
M11RF-LCD-UM 9/10/04 9:48 AM Page 11