Magnadyne M11RF-LCD Two-Way Radio User Manual


 
Timer Start:
This unit can be programmed to start and run the engine every 3 hours, 2 hours or punctually at
the same time every morning. The engine will run for the programmed running time and then shut
down.
Important! Timer start should be used only in open areas. Never start, or most importantly leave a
vehicle running in an enclosed area.
3 or 2 Hour Timer Start with Temperature Control Off:
This feature is designed for an extreme cold climate usage. The system will auto start the
vehicle every three hours to prevent the engine from freezing and creating a hard-to-start
condition. A MAXIMUM OF SIX CYCLES CAN OCCUR.
3 or 2 Hour Timer Start with Temperature Control On:
The system can be programmed to automatically start the vehicle’s engine whenever the
temperature inside the vehicle reaches and/or drops below a pre-programmed temperature
level. There are three temperature levels to choose from. A MAXIMUM OF SIX CYCLES CAN
OCCUR.
Daily Timer Start:
Press the “SET” button first, within three seconds press the button. The parking lights will
flash six times and the siren/horn will sound six times. The vehicle is now programmed to start the
next day.
Exit the Timer Start:
Timer start can be stoped manually as follows:
1. Make sure the remote start system is not operating
2. Turn the ignition “ON”. The LED and parking light will flash four times. The horn/siren sounds
for four times. Or:
1. Press the button twice to remote start the vehicle. As soon as the vehicle is running and
parking light has turned ON or are flashing
2. Immediately press the button then press and hold the button for two seconds. The
parking light will flash four times. The siren/horn will sound four times. The vehicle is no
longer programmed to start automatically.
Remote Start Operation
Interior Temperature Check
The temperature sensor can monitor the vehicle’s interior temperature through the LCD transmitter.
1. Press the SET button, within 3 seconds press the buttons. The interior temperature will be
displayed on the LCD transmitter.
13
M11RF-LCD-UM 9/10/04 9:48 AM Page 13