Filter
Top Products
5
Connection/Link to a Mobile Handset
After pairing is completed, speakerphone is always in standby mode. Before you place or answer a call,
if the headset ICON is not shown on phone screen, please follow the simple steps to activate the
Bluetooth connection/link through your handset or speakerphone until the headset ICON is on the screen.
1. On Handset: Select “BT-HFKP10” from the paired list on your handset screen.
2.
On Speakerphone: Short press multi-function button and select “Accept” on handset screen to
accept connection.
IMPORTANT: Whenever Bluetooth connection/link is removed and you cannot see the headset ICON
on phone screen, for example: power off on speakerphone/mobile handset or out of 30 feet sensing
distance, please activate connection/link as suggested.
Disconnecting from the Mobile Handset
You may connect your speakerphone to another Bluetooth handset. Please follow the steps to discon-
nect the speakerphone with the pre-paired handset.
1. Power off the speakerphone.
2. Select “disconnecting” to remove previous connection from your handset list.
IMPORTANT: Once mobile handset and speakerphone had been disconnected, for example: when the
connecting range is over 30 feet or mobile headset is power off, the speakerphone will emits 2 short
beeps per minute and LED will flash blue per 3 seconds. If mobile headset enters connecting range 30
feet with speakerphone within 10 minutes, the speakerphone will activate connection automatically and it
is not necessary to push multi-function button for to reconnect. If mobile headset doesn’t enter connect-
ing range 30 feet with speakerphone within 10 minutes, the speakerphone will power off automatically.
Using the Speakerphone
Once pairing is completed and battery is fully charged, you may access the following functions. Some
of the below-mentioned functions are only accessible for handset's supported with Hands-Free Profile.
Answering a Call:
To answer a call, wait for the ringing tone from speakerphone, then quickly press the multi-function
button to accept the call or answer the call via your mobile handset in the normal way.
Ending a Call:
Short press the multi-function button, to end your call or end the call via your mobile handset in the
normal way. You will hear a short beep from the speaker.
Reject a Call:
When you hear the ringing tone, press and hold the multi-function button for 3 seconds until you
hear a short beep.
Voice Dialing:
If your mobile handset is voice dialing enabled, under standby mode, press the multi-function button
and when you hear a beep, say the voice tag.
IMPORTANT: Please make sure to record voice tag into the mobile handset before using voice dialing
function. This function is only applicable to mobile handset with Bluetooth Hands-Free Profile. Due
to variation of phones, you may not hear the beep. Please refer to your mobile handset user guide
for additional information.
Last Number Re-Dialing:
Under standby mode, quickly press multi-function button twice for last number redial.
Adjusting the Volume:
a. During a conversation press the
-
or + button repeatedly until you reach the desired volume level.
b. During a conversation press the
-
button for 2 seconds, the speaker will be changed to low vol-
ume mode for private talk. Meanwhile, the LED will flash blue.
c. During a conversation with low volume mode activated, press the + button for 2 seconds. The
speaker will restore normal speakerphone volume.
Operation Instructions
(Continued)