Lucent Technologies 8411 Telephone User Manual


 
10
4. Place the voice terminal face down on a flat surface and turn the terminal face
down.
5. Remove the desktop stand which is attached to the base of the voice terminal by
tabs on the top and back of the stand. See Figure 7.
Press inward on the top of the stand until you can lift the top of the stand
out of the tab slot on the voice terminal.
Lift the bottom of the stand out of the lower tab slot(s).
FIGURE 7: Removing the Desktop Stand on the 8403, 8405, and 8410
6. Snap the 1-foot line cord into the LINEjack in the back of the voice terminal.
7. Pass the 1-foot line cord through the “Y”-shaped cord holder above the LINE
jack, as shown on the back of the voice terminal in Figure 8. (On some voice
terminals, you will need to pass the line cord through the channel located to the
right of the “LINE” jack.) Coil any remaining part of the cord and place it in one
of the recesses on the back of the voice terminal. (Again, see Figure 8.)
8. Snap one end of the coiled cord into the Handset jack (labeled ), as
shown in Figure 8. (On some 8403 voice terminal models, you may need to
thread the cord into the channel leading to the side edge of the voice terminal;
the handset cord will then lead off the side of the voice terminal.)
WARNING: Do not insert the handset cord into the Adjunct jack. It may cause
equipment damage.
9. Snap the free end of the 1-foot line cord into the wall jack.
10. Place the base of the voice terminal on the wall-jack mounting studs, and pull
downward until it is secure, as shown in Figure 8.