Lucent Technologies 8411 Telephone User Manual


 
7
on, the voice terminal may not have power. In this case, check the connections
and then verify that the particular voice terminal is administered on the
DEFINITY switch.)
Adjusting the 8405 and 8410 Voice Terminal Desktop Stand
To provide better display visibility on the 8405D, 8405D Plus, and 8410D set, the
desktop stand on these terminals can be installed in a high or low position. (When the
voice terminal is shipped from the factory, the stand is in the low position.) Figure 5
shows you the set of tabs to use for each position.
NOTE: On the 8411 voice terminal, you can lift the kickstand on the back of the set
to provide a better viewing angle of the terminal display.
Check which position (either the position of the desktop stand or the kickstand,
according to the type of voice terminal you are using) allows the user the best
viewing angle of the display, and then use the following short procedure for installing
the desktop stand in the selected position.
To reinstall the desktop stand on the 8405D, 8405D Plus, or 8410D voice
terminal for the low or the high position (See Figure 5.)
1. Place the lower desktop stand tab in the appropriate voice terminal tab slot.
2. Slowly lower the desktop stand until the top tab fits into the appropriate tab slot
at the top of the voice terminal. You may need to press inward on the top of the
desktop stand (see Figure 5) in order for the tab to fit into the slot.
NOTE: As noted before, if you choose to install the desktop stand in the high
position, you may need to pass the cords through the long, rectangular opening
that surrounds the jacks and then plug the cords into the jacks BEFORE you
place the stand on the back of the voice terminal.