Linear AE-1000 Telephone User Manual


 
18
AE-1000 Operation
Requesting Access with an Entry Code
Residents have up to 40 seconds to key in their entry code.
Up to eight seconds are allowed between each keystroke.
All digits of the entry code must be entered. Example: If the entry
code length is set for four digits, and the code is 0042, the user
must enter “0 0 4 2”.
If the wrong key is pressed, pressing the key will reset the
keypad. The correct code can then be entered.
After a correct code is entered, and if the conditions for granting
access are fulfi lled, the programmed relay will activate for the
programmed time.
If the number of incorrect codes entered exceeds the keypad
lockout count, the keypad will be locked and not accept any entries
for one minute.
If the Anti-passback feature is enabled, the entry code will be
unusable until the anti-passback time expires.
Requesting Access with a Wireless Transmitter
Activate a wireless transmitter within radio range of the AE-1000’s
antenna.
After a valid transmitter is decoded, and if the conditions for
granting access are fulfi lled, the programmed relay channel will
activate for the programmed time.
If the Anti-passback feature is enabled, the transmitter will be
unusable until the anti-passback time expires.
Requesting Access with a Visitor Call
Press
to view the directory.
The visitor scrolls through the alphabetical directory entries
viewing the resident names and associated directory numbers
by pressing &
on the keypad. (Holding down the keys will
scroll the display faster.)
If the visitor already knows the resident’s directory number, they
can enter the directory number to call the resident.
The system dials the resident’s telephone number to establish
2-way communications.
NOTE: The resident’s telephone number will never be displayed to
the visitor.
If the resident is using the telephone at the same time a visitor
calls, the display will indicate to the visitor that the line is busy.
The resident answers the call and converses with the visitor to
determine if access will be granted.
The resident can use their telephone’s keypad to grant access
activating Relay Channel “A” by pressing
,
or activating Relay
Channel “B” by pressing . After access is granted, the system
will disconnect the visitor and resident call.
The resident can disconnect the visitor without granting access by
pressing or by hanging up.
NOTE: The telephone keys that the resident presses can be
customized for the installation.
The length of time the visitor is allowed to talk can be programmed
from 15-255 seconds. The resident will hear a series of beeps
during the last 10 seconds of talk time. To restart the talk timer, the
resident can press
on their telephone.
220777 C IMAGE18
ENTRY CODE AT REMOTE KEYPADENTRY CODE AT LOCAL KEYPAD
ACTIVATE TRANSMITTER
ANTENNA
ENTER DIRECTORY NUMBER
OR PRESS
OR
SCROLL THROUGH THE RESIDENT
NAMES
2
TO
PRESS
TO VIEW DIRECTORY
1
3
AFTER SCROLLING, ENTER THE RESIDENT'S
DIRECTORY NUMBER AND TALK
WITH THE RESIDENT
THE RESIDENT CAN CONTROL
ACCESS USING TELEPHONE KEYS
RELAY "A"
RELAY "B"
DISCONNECT
VISITOR
TENANT