Filter
Top Products
6
EnglishEnglish
Getting Started
Phone Call Operation
Charge Battery
Turn On / Off
Function Operation
1. Plug the Charger into electric outlet. Connect the Headset and Charger as picture
shown below. The Red LED will light up.
2. When the battery is fully charged, the Red LED of Headset will switch off.
1. When power off, to turn on the Headset, press and hold S1 button for 3 seconds.
The Blue LED of Headset flashes. The user can hear a low tone of “Do” if wearing
Headset.
2. When power on, to turn off the Headset, press and hold S1 button for 3
seconds. The Red LED flashes quickly. Then, the Headset is powered
off. The user can hear a low tone of “Do” if wearing Headset.
Note:
The Headset is embedded with a
rechargeable battery. For the first time
usage, it takes about 4 hours to fully
charge the battery, and 2 hours
afterward. With Battery fully charged,
the talk-time can be up to11 hours, and
the stand-by time can be up to 200
hours.
The Headset can’t be used while it’s
in charging mode.
Pairing
Function Operation
1. The Headset must be powered off before initiating pairing. To initiate pairing, make
sure the Headset is in power off mode first, press and hold S1 button for 6 seconds
until the Blue and Red LEDs of Headset are flashing alternatively. If the user is
wearing the Headset during the pairing process, she/he will hear two short high
tones of “Do” when the Headset is ready for pairing.
2. Initial pairing process of your mobile phone.
3. You will be asked to enter pin-code to complete pairing,
enter 1234 and confirm it. The Red LED of Headset will
turn off and the Blue LED will flash quickly after pairing
completed successfully.
4. After pairing, the Blue LED of Headset will quickly flash. If with reference design in
your mobile phone, you can find a symbol of headset / handsfree function.
Note:
The 1234 is default pin-code pre-stored in Headset.
Note:
If the Headset is not in pairing mode, your mobile phone won’t find the Headset.
Please set the Headset in pairing mode before enabling your mobile phone to search
for the headset.
If no pairing happened in a period of time, approximately three minutes, the
Headset will automatically power on and the previous pairing, if any, is revoked. You
may need to repeat steps 1 to 3 until pairing succeeds.
Note:
The Red LED of Headset
will flash slowly while low
battery.
3 seconds to turn on
3 seconds to turn off
6 seconds to enter pairing
Enter 1234
7
XXXXXXXX