Filter
Top Products
IB-PH5595-WM-E-032704
CONNECTING THE TELEPHONE
(If you want to mount the telephone on the desk or the
wall, see Desk Use/Wall Mounting on page 14.)
WALL JACK
HANDSET
1.Connect the handset coiled cord to the HANDSET
and the left side of the phone.
2.Connect the straight telephone line cord to the LINE
CORD jack (rear of phone) and telephone outlet
on the wall.
If your telephone outlet is not modular, contact your
telephone company for assistance.
REAR OF THE
TELEPHONE
Step 3: Telephone Installation
GETTING STARTED
AREA CODE EXAMPLE: 718
Press UP & MENU to set
7
FIG. 1 FIG. 2 FIG. 3
1.Press the UP button till the first digit of your area code is
displayed (flashing).
2.Press the MENU button to accept and go to the next digit.
3.Repeat steps 1 and 2 above to set the 2nd and 3rd digits of
your area code.
Step 4: Setting up the Telephone
NOTE: At any time during setup, you may just pick up the
handset or press the SPEAKERPHONE button to dial
or receive a call.
Press UP & MENU to set
Press UP & MENU to set
NOTE: If you make a mistake, you can just do it over again or
call customer service for help.
SETTING UP LCD CONTRAST, LANGUAGE, AREA CODE, TIME, DATE
AND DIAL MODE
You may need to set up the LCD contrast level, language, area code, time, date and dial
mode for your telephone when you power your phone for the first time or when you move to
an area that has a different area code. This is necessary because the phone must
distinguish local or long distance calls to properly dial calls from the Caller ID list.
Press the MENU button, “LCD CONTRAST” will show in the display. Press the MENU button
again, the following will show in the display (FIG. 1). Press UP or DOWN button to choose
the LCD contrast level (1-5). Press the MENU button to confirm and accept.
Then the display will come to the language setting.
The default language “E” (“E” = English; “F” = French; “S” = Spanish) will flash (FIG. 2).
Press the UP or DOWN button to choose your desired language (flashing). Press the MENU
button to confirm and accept. If you do not press the MENU button within 15 seconds,
English will be selected automatically and will resume to the standby mode.
Then the display will ask you to set your Area Code:
While the first digit is flashing, you should:
IB-PH5595-WM-E-032704.P65 4/8/2004, 3:17 PM9