Filter
Top Products
IB-PH5595-WM-E-032704
Volume Control and Ringer Setting
Slide the HANDSET VOLUME control (LOUD or NORM).
Adjust the handset volume
Adjust the ringer level
NOTE:Only this phone will not ring, other phones on the same line will
continue to ring normally.
Last Number Redialing and Pause Function
TO CHECK THE LAST PHONE NUMBER DIALED
While the phone is not in use, press the REDIAL/PAUSE button. The number appears in
the display for 3 seconds.
NOTE: If the last dialed number exceeds 16 digits, only 16 digits will be displayed.
PAUSE FUNCTION
Example: In an office where you need to dial a 9 first to get an outside line.
Dial the number 9 and press REDIAL/PAUSE button, and then dial the phone number. You
will see a “ ” displayed for pause. You may also store this into memory..
9
Hands-Free (Speakerphone) Operation
ANSWERING CALLS WITH THE SPEAKERPHONE
1.After the phone rings twice, press the SPEAKERPHONE button, the SPEAKERPHONE
INDICATOR will light, and the hook icon will show in the display..
2.The display will show the Count Up Call Timer after a few seconds.
3.Adjust the speakerphone volume by sliding the SPEAKERPHONE VOLUME control on
the right side of the phone.
4.To end the call, press the SPEAKERPHONE button again.
5.The SPEAKERPHONE INDICATOR will go off and the display will return to the normal
mode.
MAKING CALLS WITH THE SPEAKERPHONE
1.Press the SPEAKERPHONE button to get a dial tone - no need to lift the handset.
2.The SPEAKERPHONE INDICATOR will light and the hook icon will show in the
display, the Count Up Call Timer will start after a few seconds.
3.Adjust the speakerphone volume by sliding the SPEAKERPHONE VOLUME control on
the right side of the phone.
4.Dial your call.
5.To end the call, press the SPEAKERPHONE button again.
6.The SPEAKERPHONE INDICATOR will go off and the display will return to the normal
mode.
NOTE: When pick up the HANDSET or press the SPEAKERPHONE button, the hook icon
will show in the display. If this icon shows in the display while the phone is not
in use, remember to check if the HANDSET is replaced properly or the
SPEAKERPHONE button is pressed to off.
Set RINGER HI/LOW/OFF switch.
HI - loud rings on incoming calls.
LOW - lower rings on incoming calls.
OFF - no ringing on incoming calls.
If you have subscribed to the Caller ID service, the caller’s number and/or name appears in
the display when you received a call (see page 11).
1.Pick up the HANDSET or press the SPEAKERPHONE button. The hook icon will
show in the display.
2.Press the REDIAL/PAUSE button. The last dialed number appears in the display and is
automatically dialed.
IB-PH5595-WM-E-032704.P65 4/8/2004, 3:17 PM11