Filter
Top Products
21
CONFERENCE GUIDE SETTINGS
When a multi-party call is going to be connected, a special signal (ash or R-pulse) is
produced which transmits the command (request, return and conference) to the PBX. It
may be necessary to change the type of signal if calls are connected via a PBX. Different
PBXs may require different signals. These requirements should be specied in the techni-
cal data for the PBX. Settings for the most common PBXs are listed on Konftel’s website.
Select MENU > CONF GUIDE > SETTINGS (3,6).
Enter the command for a request for a new dialling tone and press OK to conrm. (“F”
is the default setting)
Enter the command to connect everyone to a multi-party call and press OK to conrm.
(“F3” is the default setting)
Enter the command to return to your original call and press OK to conrm. (“F” is the
default setting)
If you experience problems making multi-party calls
It may be necessary to change the duration of the pulse so that it works with your PBX.
Read “Adjusting Flash/R-pulse duration” on page 28.
Your PBX may not be programmed to admit multi-party calls or the procedure may be
different. Please contact your telephone administrator or service provider.
DISPLAYING CONFERENCE GUIDE STATUS
Select MENU > CONF GUIDE > STATUS (3,7).
The display screen indicates the number of conference groups already stored plus how many more
groups can be added.
CONFERENCE GUIDE