Filter
Top Products
12
Registering the Konftel 300W with a DECT base station
Select MENU > SETTINGS > DECT > REGISTER (2,1,2) to start the registration guide
in the Konftel 300W.
Please note that you must conrm all your choices by pressing OK.
Select base (1–4).
Four base stations can be registered in the Konftel 300W. If no base station has been
programmed, choose no. 1. Numbers being used are indicated by a lled box.
Enter the base station’s security code (PIN code).
The code is 0000 for the Konftel DECT base station. Check with your company’s
switchboard administrator if a different DECT system is being used.
The Konftel 300W is now in registration mode and is searching for a base station in registration
mode. Wait until you receive conrmation that registration has been completed. (The base station
has to be in registration mode.)
Registration can be interrupted by pressing C. If registration was successful, the word
READY will appear in the display.
The Konftel 300W is now ready to use.
Please see page 27 for other menu options and settings.
If registration was not successful
If registration was not successful, the word Fail will appear in the display. Possible
reasons for this:
• Incorrect security code (check with your company’s switchboard administrator)
• Incorrect or missing PARK code (check with your company’s switchboard administra-
tor)
• No base station within range or not activated in registration mode
CONNECT TO A DECT SYSTEM