Filter
Top Products
18
KEY ASSIGNMENT MODE
This transceiver allows you to reprogram the PF-1 key (press/
hold) and PF-2 key (hold only) with any of the functions listed
in the table below. Explanations on the use of each function are
provided under “PROGRAMMABLE FUNCTIONS”, on page 19.
Table Number Function Name
0 None (no function)
1 Low Transmit Power
2 Monitor (PF-2 key hold default)
3 RX/TX Frequency Scan *
4 Scan (PF-1 key press default)
5 Squelch Off
6 Super Lock-C
7 Super Lock-P (PF-1 key hold default)
8 Tone Alert
* To use this function, Repeater mode must be activated through
Programming Software.
To change the functions of the PF-1 and PF-2 keys:
1 With the transceiver power OFF, press and hold the Up and
PF-2 keys while turning the transceiver power ON.
• Continue to hold the Power switch, Up key, and PF-2 key until
the LED indicator lights yellow and the transceiver announces
“Setup”.
2 Release the Power switch, Up key, and PF-2 key.
• The transceiver announces “Table Zero”.
3 Press the Up/Down keys to increment/ decrement the
number, to select the new key function.
• Table numbers and their corresponding functions are provided
in the table above.
• A voice announcement will inform you of the currently selected
Table number.