Filter
Top Products
18
EN
Time Code
During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded
scene on the tape during playback.
If recording starts from a blank portion, the time code begins counting from “00:00:00”
(minute:second:frame). If recording starts from the end of a previously recorded scene, the time code
continues from the last time code number.
If during recording a blank portion is left partway through the tape, the time code is interrupted. When
recording is resumed, the time code starts counting up again from “00:00:00”. This means the camcorder
may record the same time codes as those existing in a previously recorded scene. To prevent this, perform
“Recording From The Middle of A Tape” below in the following cases;
• When shooting again after playing back a
recorded tape.
• When power shuts off during shooting.
• When a tape is removed and re-inserted during
shooting.
• When shooting using a partially recorded tape.
• When shooting on a blank portion located
partway through the tape.
• When shooting again after shooting a scene
then opening/closing the cassette holder cover.
Recording From The Middle Of A Tape
1. Play back a tape or use Blank Search (੬ pg. 22) to find the spot at which you want to start recording,
then engage the Still Playback mode (੬ pg. 19).
2. Set the Power Switch to “ ” or “ ” while pressing down the Lock Button located on the switch, then
start recording.
NOTES:
● The time code cannot be reset.
● During fast-forwarding and rewinding, the time code indication does not move smoothly.
● The time code is displayed only when “TIME CODE” is set to “ON” (੬ pg. 35, 37).
Shooting start point
Newly recorded sceneBlankAlready recorded scene
Time code
05:43:21
Time code
00:00:00
Tape
Time code
00:00:00
Shooting start pointShooting stop point
Latest sceneNew sceneAlready recorded scene
Frames
(25 frames = 1 second)
Seconds
Minutes
Frames are not displayed
during recording.
When a blank portion is recorded on a tape
Proper recording
Time code
00:00:00
Time code
05:43:21
Time code
05:44:00
Shooting start point Shooting start point Shooting start point
Tape
12:34:24
RECORDING
(cont.)
Display