Filter
Top Products
Grandstream Networks, Inc. HT-502 User Manual Page 21 of 35
Firmware 1.0.0.39 Last Updated: 03/2007
T
ABLE 8: HT–502 DEVICE STATUS PAGE DEFINITIONS
MAC Address
The device ID in HEX format. This is needed for ISP troubleshooting. Note there
are separate MAC addresses for the WAN side and the LAN side.
WAN IP Address
Shows WAN IP address of HT–502.
Product Model
Contains the product model info.
Software Version
Program: This is the main software release. Boot and Loader are seldom
changed.
System Up Time
Shows system up time since the last reboot.
PPPoE Link Up
Indicates whether the PPPoE connection is up if the HT–502 is connected to DSL
modem.
NAT
Indicates the type of NAT connection used by the HT–502 via its WAN port.
Based on STUN protocol.
Port Status
Shows several information regarding the individual FXS ports.
Port Hook Registration DND Forward Busy
Forward
Delayed
Forward
FXS1 On Hook Registered
Yes 613
FXS2 On Hook Registered
No 614
• Both FXS port1 and FXS port2 are registered with this SIP Server.
• FXS Port 1 user has set Do Not Disturb.
• FXS Port 1 user has set his calls to be forwarded unconditionally to ext 613.
• FXS Port 2 user has set his calls to forward to 614 when his phone is busy.
ADVANCED USER CONFIGURATION
Log in to the advanced user configuration page the same way as for the basic configuration page. The
password is case sensitive and the factory default password for Advanced User is “admin”.
Advanced User configuration includes the end user configuration and the advanced configurations
including: a) SIP configuration, b) Codec selection, c) NAT Traversal Setting and d) other miscellaneous
configuration. HT-502 each FXS SIP account has its own configuration page. Their configurations are
identical.
T
ABLE 9: HT–502 ADVANCED CONFIGURATION PAGE DEFINITIONS
Admin Password
This contains the password to access the Advanced Web Configuration page.
This field is case sensitive. Only the administrator can configure the “Advanced
Settings” page. Password field is purposely left blank for security reasons after
clicking update and saved. The maximum password length is 25 characters.