Filter
Top Products
28
REMOTE OPERATIONS
1. Call the number to which the
answerer is installed.
The answerer will pick up after the
set number of rings.
2. Wait for the announcement to
end or press 6 to bypass the
announcement.
3. Enter the correct three-digit
security access code.
The answerer will accept three
attempts to enter the correct
security access code before discon-
necting the call.
If in Announce Only mode and the
correct security access code is not
entered within 8 seconds, the
answerer will disconnect the call.
After the correct code has been
entered, the answerer provides a
status check and then emits a ready
tone.
5. Enter a remote command.
After each operation is completed,
the answerer will emit a ready tone.
6. When you are finished with
remote operations, hang up the
phone.
Cut out the cards to the right and carry them
with you for quick reference of remote
operation commands.
Play new messages press 8
Rewind press 1
Play or Pause press 2
Fast Forward press 3
Record announcement press 4
Erase press 5
Stop press 6
Room Monitor press 7
On or Off press 9
Memo press 0
Help press #
To:
Press:
Remote Digital
Messaging Operations
2-9950
1. Dial phone number of the
answerer.
2. Press the # key to enter
the Remote Access mode.
3. Enter 3-digit security code.
4. Enter touch-tone com-
mand.
5. Hang up.
CUSTOMER: CUT ALONG DOTTED LINE.
✂