GE 2-9892 Answering Machine User Manual


 
26
GE 2 9892 5 x 7 08/2/94 BOOKS folder
FONTS: Helvetica, Helvetica Bold, Century Schoolbook
IN CASE OF DIFFICULTY
1. Tape won’t go in.
2. Power was applied without tape
installed
Unplug the DC power cord and plug it in again.
Wait for unit to stop. Then, insert tape. Unplug
DC power cord.
Then plug it in again. (This resets the unit).
3. Answer indicator flashes rapidly
and there are no new messages
Record new Outgoing Announcement.
If problem recurs, clean heads.
4. Answer
ON/OFF
is not on
Is Answerer switched
ON
? Press Answer
ON/OFF
switch.
Is the DC Adapter inserted properly and securely
into working AC outlet?
ANSWERER PROBLEM SOLUTION
1. System does not respond to
commands
Check to make sure you are using Touch-Tone
phone.
Start entering codes before ten second time-out.
Enter correct three digit security code.
Press dial buttons firmly. (There may be noise
interference on the phone lines.)
2. System doesn’t answer until the
tenth ring.
Answerer is turned off.
Enter three digit security code to turn on (p. 24).
If tape is full, enter Security Code, then listen to
and delete messages to make room for more
messages (p. 24).
REMOTE OPERATION
PROBLEM
SOLUTION
5. Unit will not function when I press
any buttons.
6. The unit does not function.
However, Beep sounds and Call
Counter flashes.
Replace tape and unplug and then plug in DC
power cord. (This resets the unit).
If tape is running, wait for tape to finish rewind.
Note: Do not plug unit in without tape installed.
7. The unit does not record Incoming
messages
8. Sound level of Messages played
back is low
Turn Volume Control up.
Clean the head and capstan assembly
9. Outgoing Announcement does not
stop and no incoming message is
recorded
Re-Record Outgoing Announcement.
Clean the head and capstan assembly
If tape is running, wait for tape to finish rewind.
Note: Do not plug unit in without tape installed.
Unplug AC power cord. Then plug it in again.
(This resets the unit.)
Is tape inserted properly?
Does tape appear damaged? If so, replace.
Is Outgoing Message recorded properly?