Filter
Top Products
21
GE 2 9892 5 x 7 08/2/94 BOOKS folder
FONTS: Helvetica, Helvetica Bold, Century Schoolbook
ANSWERING SYSTEM OPERATION
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
You can use the volume control on the side of the Answer-Phone
TM
to adjust the volume of the system’s speaker. Slide the switch until
you find a comfortable volume level.
To screen calls, set the system to answer calls, and adjust the
VOLUME
setting so you can hear the
OGA
and the caller’s
message on the Answer-Phone
TM
’s built-in speaker.
If you decide to take the call, lift the handset of the Answer-
Phone
TM
or any extension on the line. The system will
automatically stop recording and you may speak to the caller.
H.
Screening
Your Calls
G.
Message
Volume
Control
If you wish to get rid of your old messages and want to set the
tape to have new messages record over the old messages:
Press the
MESSAGE RESET
button.
•
MESSAGE LED
will clear
• New incoming messages will record over old messages on
the tape.
I.
Message
Reset
Press and hold down
MEMO
button. Start recording after the
tone. Speak into the microphone and release the
MEMO
button
when finished. The unit will record the time and day stamp and
the
MESSAGES
indicator will be advanced by one count.
J.
Recording
a Memo
When the system’s tape is full, the
MESSAGES
indicator will
flash rapidly. The unit will answer on the tenth ring, and beep
once. If the caller does not enter the unit’s (factory set three digit)
security code within ten seconds, the Answer-Phone
TM
will hang
up. To make room for new messages, press
PLAY/STOP
to
listen
to your messages, press
MESSAGE RESET
to erase them.
K.
When Tape
is Full
VOLUME
LO
HI
VOLUME
LO
HI
MEMO MESSAGE RESET PLAY•STOP
FLASH REDIAL
MESSAGES
MEMORY
MEMO MESSAGE RESET PLAY•STOP
FLASH REDIAL
MESSAGES
MEMORY
MEMO MESSAGE RESET PLAY•STOP
FLASH REDIAL
MESSAGES