GE 2-9892 Answering Machine User Manual


 
18
GE 2 9892 5 x 7 08/2/94 BOOKS folder
FONTS: Helvetica, Helvetica Bold, Century Schoolbook
ANSWERING SYSTEM OPERATION
Your GE Model 2-9892 Answer-Phone
TM
provides an incoming
caller with your outgoing announcement and then records an
incoming message (from the caller).
The incoming call will be automatically answered on the third
ring. Because of the single microcassette operation, callers
must wait for the tape to fast forward past any previous
messages before they may leave their message. During this
time, a pleasant melody is played over the phone.
When you are at home,
you can use your new system to:
Answer calls when you cannot answer the telephone.
Screen incoming calls when you do not want to be disturbed.
Take messages from callers.
Record memos directly using the unit’s built-in microphone.
The Answer-Phone
TM
disconnects automatically if a calling party
hangs up or stops talking. The unit also places a time and day
stamp on each incoming message or memo.
When you are away,
you can use any touch-tone phone to:
Listen to messages.
Bypass the announcement and leave a message quickly.
Repeat your messages.
Turn your answering system on.
Change your announcement.
Leave a memo
A three digit, factory-set security code is written on the bottom
of the Answer-Phone
TM
. Your security code must be entered to
use any remote functions. This code prevents unauthorized use
of remote operation.
A.
Introduction
The Time and Date is added to the end of each message or
memo. Before using your new Answer-Phone
TM
the time/day
stamp should be properly set.
1.
Adjust VOLUME control to a comfortable level.
When you power-up the unit, the answerer is automatically
turned on.
Open the
DOOR
to expose the Answer Controls.
2.
To set hour.
Advance the hour by pressing and holding the
HOUR
button
until the
VOICE
announces the correct AM/PM hour.
3.
To set minute.
Advance the minute by holding the
MINUTE
button. Voice
will announce minutes in five minute increments. Tap the
MINUTE
button for 1 minute increments
B.
Setting the
Time/Day
Stamp
VOLUME
LO
HI
PU