Filter
Top Products
23
CHANGING THE SECURITY CODE
The default security code for accessing the
answerer from another location is 1234. You
must use the handset to change the secu-
rity code. With the phone off, follow these
steps:
1. Press ANSWERER.
2. Press # key.
3. Enter 4 numbers to be used as the new
security code.
4. Press ANSWERER again.
*
0
#
TONE ERASE OPER
INTERCOM ANSWERER
TALK
INTERCOM ANSWERER
TALK
2. Enter # key followed by the security code after you hear the tone.
3. Follow the voice menu to use the answerer's remote functions or follow
the table below.
The remote feature enables you to perform the following functions:
To Press this Button
Review voice menu options 1
Review message 1(during message playback)
Play back messages 2
Pause message playback 2 (during message playback)
Erase message 0 (during message playback)
Skip message 3 (during message playback)
Stop message playback 4
Turn off answerer 4
Memo Recording 5 (Refer to page 22 for instructions)
Room Monitoring 7
Announcement Record 8
Announcement Playback 9
Playback Speed 6 (during message playback)
Exit remote access mode
*
NOTE : Set 0000 to disable remote access.