Filter
Top Products
7
1. Plug the telephone line cord into the base and into a modular jack.
2. Plug the power supply cord into the base and into an AC outlet.
3. Set the PULSE/TONE switch to TONE for touch-tone service, or PULSE
for rotary service. If you don’t know which type of service you have,
check with the phone company.
4. Select either OFF, LO, or HI (on the base) for the preferred ringer
volume. If you select OFF, the handset will not ring with incoming calls
or paging, but the TALK button will light.
5. Raise the base antenna.
6. Place handset in the base to charge for 8 hours. The CHARGE light
comes on indicating that the battery is charging. A low battery warning
(BATT LOW light and warning tone) will remind you to charge the
handset batteries for at least 8 hours.
NOTE: Use only the Thomson 5-2387 power supply that came with this unit.
Using other adapters may damage the unit.
DESKTOP
INSTALLATION
1
PULSE/TONE switch
3
4
Ringer volume switch
5
6
2