Filter
Top Products
17
Unit beeps and • Place handset in base for 10 seconds to reset the
TALK light blinks
phone. If that doesn’t work, charge battery for 8 hours.
• Clean charging contacts on handset and base with a soft
cloth, or an eraser.
• See solutions for “No dial tone.”
• Replace battery.
Cannot place calls because • You are receiving an out-of-range alert, move closer
TALK light continues to flash
to the base.
Cannot hear the • Set the RINGER volume to LO or HI.
Page alert tone
Range is shorter • Press the CHAN button during the conversation to select a
than normal new channel.
• Position the base antenna upward.
• Check that the handset antenna is screwed in tightly.
Battery will not hold a • Be sure you are sufficiently charging the battery. When the
charge OR is fully charged battery has been charged for 8 hours, you can expect
and the BATT LOW light approximately 4 hours of talk time. You may want to
continues to blink. consider purchasing an extra battery to provide you with the
convenience of always having a fully charged replacement
battery.
• Check to be sure battery contacts on both the handset and
the base are making contact and are clean; free of dirt or lint.
• When the handset is placed in the base, check that the base
CHARGE light is on.
BATT LOW light stays on • Place handset in base for 10 seconds to reset the
phone. If
that doesn’t work, charge battery for 8 hours.
Memory Dialing does not
• Did you program the memory location keys correctly?
work See p. 12.
• Did you follow proper dialing sequence? See pp. 12-13.
• Make sure TONE/PULSE switch is correctly set.
See pp. 7-8.
Phone does not work • Install a fully charged spare battery in the base charging
during a power failure
station.
Problem Solution