Filter
Top Products
7
Intercom Operation
(applicable only with additional handsets)
The intercom feature allows you to have a conversation with another registered
handset without tying up the telephone line, allowing you to still receive incoming calls.
Making an Auto Intercom Call
1. Make sure the handset is OFF (not in TALK mode).
. Press the
delete/int/conf button on the handset.
. Use the touch-tone pad to select the handset you want to page.
NOTE:
a) If the user has not entered the paged handset number within a
few seconds, the handset shall display a paged handset number
list (i.e. Handset 2, Handset 3, Handset 4, Handset 5 and Handset
6) if Handset 1 is paging the handset.
b) Even if the handset has not been registered with all 6 handsets,
the paging list will display all handset numbers.
c) If the user has selected a paged handset number that has not
been registered, the handset will emit an error tone and ask the
user to retry again.
4. A long beep is heard and then the two handsets are immediately connected.
Receiving handset shall immediately come into the auto intercom mode that both
“microphone” and “speaker” of this receiving handset shall be enabled such that
the user of receiving handset can freely talk and listen to the conversation.
5. When nished, press the
END button or delete/int/conf button on either handset
to deactivate the intercom.
NOTE: The system is expandable up to 6 handsets (by purchase
of optional Model 28203 handset with recharge cradle). When
4 handsets are registered, the system can handle 2 separate
intercom operations at once, for example, 1st handset intercoms
with 2nd handset while 3rd handset intercoms with 4th handset.