GE 25423 Intercom System User Manual


 
35
Chain Dialing
This process allows you to dial a succession of stored numbers from separate memory
locations. This is useful when you must dial several sequences of numbers, such as with
frequent calls via a telephone company long distance provider.
For example Memory location
Local access number of long distance company 6
Authorization code (ID) 7
Long distance phone number 8
1. Press the line you want.
2. Press memory location 6.
3. Press memory location 7.
4. Press memory location 8.
Display Messages
The following special messages indicate the status of a message or the unit:
00 TOTAL CALLS The Caller ID memory log is empty.
UNKNOWN CALLER The incoming call does not have Caller ID service or their
service area is not linked to yours. If UNKNOWN CALLER
appears along with a calling number, the name information for
that number was not available.
BLOCKED CALL The caller is registered as “Private Number ”and their Caller ID
information is withheld.
INCOMPLETE DATA Caller information has been interrupted or corrupted during
transmission.
NO DATA No Caller ID signal has been detected, or Caller ID service has not
been activated.
START/END You are at the beginning or the end of the Caller ID memory log.
Battery power level is low.
Operation By Battery
If the power cord is not plugged into the unit, and the battery is available, the unit enters
Battery Operation Mode. In this mode, the unit fully supports all operational features,
except the intercom call function and cordless handset.
NOTE: Under battery operation mode, the RF module (optional for use with cordless handset)
is not supported.
Memory