GE 25423 Intercom System User Manual


 
13
Connections & Setup
VERY IMPORTANT: In order to achieve full system operation (i.e. intercom, page, etc.), Line
1 must be connected and must be common to all phones connected to the system. Only
other 25413/14/15 models are compatible for full system operation. For proper operation of
intercom, page function, etc., DO NOT connect a DSL modem to Line 1.
• To set your own Phone ID, or change your phone ID, follow the steps in the Phone ID
section.
You may connect up to 16 RCA 25423, 25424 and/or 25425 phones to the system at
one time. Features like intercom, page and call transfer may be used among the units,
but Line 1 must be common for all 25423, 25424, or 25425 units for these features to
work properly. You may choose to share or privatize lines 2, 3 and 4.
5. Connect the handset cord:
Connect one end of the coiled handset cord to the jack on the side of the base and the
other end into the jack in the handset, and place the handset in the cradle.
6. Check for a dial tone:
Lift the handset and listen for a dial tone. If you hear a dial tone, the phone is
properly installed.
Data Port
This phone has a data port jack to connect an auxiliary phone device, such as a fax
machine, computer modem, answering machine, or even a cordless phone.
The data port switch on the back of the phone controls the data port jack so you can
choose Line 1, Line 2, Line 3, or Line 4.
Use the data port to hook up your fax machine, for example, and then set the data port
switch to Line 4 in order to receive faxes on the phone number for Line 4.
If you are talking to someone on Line 4 and want that person to fax something to you,
change the data port switch to Line 2 or Line 3, and give the person on-line the phone
number for Line 2 or Line 3. Your fax machine now can receive calls on Line 2, Line 3,
or Line 4.
IMPORTANT: Be sure to switch the fax machine back to the normal line when you are done
because outside callers who do not know that you have switched lines will not be able to
reach your fax machine if they dial the Line 4 number.
System Verification
Use the following procedures to test system configuration and identify possible line
connection errors. The phone must be connected to the power outlet, Line 1 must be
connected to the Line 1 + 2 jack, and the phone must have a phone ID.
VERY IMPORTANT: In order to achieve full system operation (i.e. intercom, page, etc.), Line
1 must be connected and common to all phones on the system. Only other 25423, 25424,
25425, 25413, 25414, 25415, 25403 and 25404 models are fully compatible.