GE 25423 Intercom System User Manual


 
14
Other System Phones
1. Press Line 1.
2. Look at all the other stations. If they all indicate line 1 is being used, the connection is
correct.
OR
1. Press the Intercom button. The display shows INTERCOM and ENTER CALLING PHONE ID.
2. Enter a phone ID by pressing an Intercom/Memo Log button (1-16). The display shows
the phone ID you entered. If the phone ID you entered is connected to the system, you
will hear a ring back tone (call through tone) at your phone. If the phone ID is not
connected to the system, you will hear an error tone. NO ANSWER shows in the display
and intercom is cancelled.
Programming the Telephone
When programming the phone, if at any time you wish to discontinue or stop
programming, press the “Exit” button. Also , whenever you have made a program selection
by pressing the Sel/Save button the display will shown “OK” for several seconds then will
return to the MAIN MENU prompt display.
Language
Set the display language to show messages in either English, Spanish, or French.
1. Press the Menu button while in standby mode. The cursor in the display points to
SET LANGUAGE.
2. Press the Sel/Save button.
3. Use the Vol (+ or -) buttons to scroll up or down to ENGLISH, ESPANOL, or FRANCAIS.
The default is English.
4. Press the Sel/Save button to save.
Volume
The ringer, speaker, and handset/headset volume is set independently with the
Vol (+ or -) buttons. There are 8 possible volume settings per mode. The volume indicator
scale is displayed during volume adjustment.
Ringer Volume
1. While the phone is on the hook, press the Vol (+ or -) button. The phone rings
according to the current setting.
2. Tap the Vol (+ or -) buttons to adjust the volume one level at a time. The phone stores
the setting after the last button press.
NOTE: To turn the ringer off, on, or change the ringing pattern, see Setting the Ringer Tone.
Programming the Telephone