GE 25210 Intercom System User Manual


 
17
Registration (only applicable to handset)
A cordless handset will not operate until it is registered to the base. During
the registration process, keep the handset near the base. Up to 10 cordless
handsets can be registered to one base.
NOTE: If a handset has not been registered to the base, then the screen
displays “PRESS “REG” TO INITIATE REGISTRATION” once the handset has
been activated. Press the REG soft key to start the registration.
From the Phone Setting Menu:
1. Press the
VOL (+ or -) button to scroll to Registration.
2. Press SELECT soft key and you may program the following items:
Register and Remove handset.
Register
From the Phone Setting Menu:
1. Press the
VOL (+ or -) button to scroll to Register.
2. Press SELECT soft key. The screen displays
“Press base unit Page button
until beep”.
3. Press and hold the
Page button on base for 5 seconds.
4.
“Registration” displays to indicate the base is now in registration mode.
5. If the registration is successful, the screen displays “
Registration
complete” for 2 seconds and emits a confirmation tone.
6. If the registration is failed (i.e. timeout), the screen displays
“REGISTRATION FAILED!” for 2 seconds and emits an error tone.
Remove Handset
De-registration cancels registration. During the de-registration process,
keep the handset near the base.
WARNING: It is not recommended that a handset be
deregistered unless absolutely necessary because once a
handset is deregistered, that handset’s telephone features
cannot be used until the handset is re-registered.
From the Phone Setting Menu:
1. Press the
VOL (+ or -) button to scroll to the Remove handset.
2. Press SELECT soft key button. The screen displays
“Remove handset?”.
3. Press the YES soft key to confirm de-registration. The screen displays
“Saved” and then displays “Press “REG” to initiate registration” in the
handset.
NOTE: You can press the REG soft key to enter the registation mode again.
Programming the Telephone