GE 25210 Intercom System User Manual


 
36
Display Messages
The following messages show the status of the phone, provides Caller ID
information, or helps you set up and use your phone.
DELETE ALL? Prompt asking if you want to erase all records.
DELETE? Prompt asking if you want to erase the current record.
END/ START Indicates that it is the end of the list.
ENTER NAME Prompt telling you to enter a name.
ENTER NUMBER Prompt telling you to enter a telephone number.
NEW CALLS Indicates call or calls which have not been reviewed.
HANDSET NAME Prompt telling you to enter a user name for the hand
set.
UNAVAILABLE Indicates that the function you want to initialize
cannot work at that moment or the function being
worked cannot continue. The system is busy or some
other higher priority function is being performed.
For example, the message playback function will be
stopped when there is an incoming call.
NO LINE Indicates that the telephone line is not connected.
LINE IN USE Display on handset while the line is in use.
EMPTY Indicates there are no CID records in memory.
OUT OF RANGE Indicates handset is too far away from the base, and
the handset is searching for the base.
BLOCKED Indicates the person is calling from a number which is
blocked from transmission.
UNKNOWN Indicates incoming call is from an area not serviced by
CID or the CID information was not sent.
Handset Sound Signals
Signal Meaning
A long warbling tone (with ringer on) Signals an incoming call
Two short beeps (several times) Page signal
One beep every 14 seconds Low battery warning
One long beep after press one key Confirm
A short warbling tone (with ringer on) Error
Display Messages