Filter
Top Products
25
STORING A REDIAL NUMBER
1. Make sure the phone is OFF (not in TALK mode).
2. Press the DIR soft key to display SELECT MEMORY 01-50.
3. Press any number key (01-50) to store the phone number in that
memory location, or press cid/vol (up and down arrow) button to scroll
to the desired memory location.
4. Press the EDIT soft key and ENTER NAME shows on the display.
5. Use the touch tone pad to enter the name, then press the OK soft key
and ENTER TEL NUMBR shows on the display.
6. Press the redial button to display the redial number.
7. Press the OK soft key again to confirm.
NOTE: If the redial number has more than 24 digits, the redial number
cannot be stored in memory.
INSERTING A PAUSE IN THE DIALING SEQUENCE
Press the # button on the handset number pad to insert a delay in
dialing sequence (of a stored telephone number) when a pause is
needed to wait for a dial tone (for example, after you dial 9 for an
outside line, or to wait for a computer access tone.) Each pause counts
as one digit in the dialing sequence.
REVIEWING, CHANGING, OR DELETING INFORMATION STORED IN MEMORY
To Review:
1. Make sure the phone is OFF (not in TALK mode).
2. Press the DIR soft key to display SELECT MEMORY 01-50.
3. Press the cid/vol (up or down arrow) buttons to scroll the stored names
and numbers, or use the handset number pad to enter the memory
location number.