Filter
Top Products
v
Specifications of MF/HF Radiotelephone model FS-1562
The model FS-1562-15/25 complies with the following rules and regulations:
- IMO A.421(XI), A.610(15), A613(15), A.694(17)
- International Convention on Safety of Life at Sea 1974, as amended 1988 (GMDSS Conference)
- ITU Radio Regulations
- ETS 300 373
- IEC 1097-9 draft, IEC 945 General Requirements
- EC EMC Directive for CE marking requirements
- Other relevant rules
GENERAL
Communication System Simplex or semi-duplex
Frequency Range 1.6 to 27.5 MHz (transmit), 0.1 to 30 MHz (receive)
Frequency Resolution Transmit: 100 Hz Receive: 10 Hz
Class of Emission J3E SSB, suppressed carrier, signal channel containing analogue information, telephony;
when 2182 kHz is first selected, H3E is set.
H3E SSB, full carrier, signal channel containing analogue information.
J2B for DSC, NBDP; SSB, suppressed carrier, signal channel containing quantized
or digital information with the use of a modulating sub-carrier, telegraphy for
automatic reception
F3C weather facsimile, reception only
Frequency Error ±10 Hz (Both Transmitter and Receiver)
Number of Channels Custom channels: 200 max programmed by Furuno authorized service representatives
ITU SSB/TELEX Channels as listed in Appendix
2182 kHz (single action)
2187.5 kHz (automatically selected on DSC equipment)
Environmental IEC 945: -15°C to +55°C Transceiver unit, -25°C to +70°C ACU; 93% at 40°C
Power Supply 24 VDC +30%, -10%. For AC, a rectifier unit required.
Receive: 2 A
Transmit (max.): FS-1562-15...20 A
FS-1562-25...40 A
Radiotelephone Signal Generator Two tones of 2200Hz and 1300Hz transmitted alternately.
TRANSMITTER
Output Impedance 50 ohms
Output Power J3E/H3E: FS-1562-15...150 W pep, FS-1562-25...250 W pep
J2B: FS-1562-15...150 W pep, FS-1562-25...250 W pep
(FEC mode: reduced to 60 W)
Tune: 10 to 20 W approx.
Power Reduction 60 W
Controls Output HI/LOW, test
ANTENNA COUPLER
Power Capability AT-1560-15...150 W pep
AT-1560-25...250 W pep
Tuning System CPU controlled fully automatic tuning system