Filter
Top Products
-1.9-
• The [CURS (cursor)] key shifts the cursor to band or channel number.
• To change the channel number, you can use the rotary control. The [FREQ/CH] control changes
the number above the cursor, a band or channel designator.
ITU TELEX channels
To select the ITU TELEX channel 4012, for example, first select TLX with the [MODE] key.
This radiotelephone is furnished with J2B class of emission. The J2B is compatible with F1B
which may be used on other parties. You do not have to worry about F1B or J2B; you can just
select TELEX mode for narrow-band direct-printing.
Press [RCL], [4], [0], [1], [2], [ENT], and a combination of TX frequency of 4178.0 kHz and
RX frequency of 4215.5 kHz is selected with the display as below. To select only RX or TX
frequency, hit [RX] or [TX] to start with.
R
02
4
6810
S
TLX
AGC
DUP
R
02
4
6810
S
TLX
AGC
DUP
TX freq
RX freq ITU CHANNEL NO.BAND
NOTE: You can recall an ITU channel by entering 3 or 4 digits. To recall ITU telex channel 4012
by three digits, for example, select “TLX” then enter 412 (instead of 4012).