Filter
Top Products
3-3
For technician
Please pass on the following information to the customer.
• When the auto tuning circuit is broken, transmission is available by the manual tuning (setting
the S1 switch to MANUAL).
• Do not change the settings of DIP switch in the antenna coupler.
3.3 System Setup
Enter system settings as below after the installation. To prevent accidental transmission of
the distress alert, disconnect the antenna. These settings should be entered by a qualified
technician. The installer enters system settings on the System Setup menu. A password is
required to access this menu. Under no circumstances shall the operator access the
System Setup menu.
3.3.1 Opening the System Setup menu (DSC)
1. Press the [SETUP] key to display the Setup menu.
2. Rotate the
[ENTER] knob to select “SYS SETUP”.
3. Enter the password referring to appropriate FURUNO INFORMATION to display the
System setup menu. The password cannot be informed customers by statute.
System Setup
EQUIPMENT TYPE : 1570
PROTECTION : OFF
DSC SYSTEM SETUP
RT SYSTEM SETUP
LOAD DEFAULT
TEST
System setup menu
3.3.2 DSC SYSTEM menu
Choose “DSC SYSTEM SETUP” on the System setup menu, and then press the [ENTER]
knob to show the DSC System setup menu.
DSC System setup
MMSI: xxxxxxxxx FIXED
MODEM OUT : 0.0
dBm
SIG DET S LEVEL : 100
REGULATION : INTL
CLASS : MF/HF
DIST : PANEL1
2006-04-01 00:00:00
DSC System Setup menu
MODEM OUT
Adjust the level of the modem output for DSC (DSC modem, NBDP modem, NBDP modem).
Normally, this setting is not required.