Filter
Top Products
LinkPlus Interface Guide: Fujitsu F9600 Telephone System
PN: 1725-36134-001_E.doc
18
Using the Autodial feature
1. To use the Autodial feature, perform the following steps:
2. Press
START on the same handset that was programmed above.
3. Press the Autodial key sequence for the number to be dialed (
FCN
+4, FCN +5, FCN +9, or FCN +*).
The pre-programmed number is then dialed.
4. Wait for your party to answer.
5. Press
END when the call is completed.
Effect of power loss
Note that the Autodial numbers are stored in the MCU/Gateway and
each number must be reprogrammed per step a through f each time
the system loses power or is shut off.