Filter
Top Products
Interface Implementation
PN: 1725-36134-001_E.doc
1
7
Note: The following features should not be assigned to the PTB 4xx,
and should not be assigned to other SpectraLink Wireless Telephones
if they are not supported on the handset:
• AUTO ANSWER
• DIAL-BY-NAME
• All DATA features
• FORCED CALL FORWARD
• FLEXIBLE CALL FORWARD
• HEADSET
• All TCSI features
When programming is complete, the installer can test the handsets.
Programming an Autodial Number in the
Handset
The SpectraLink 6000 System supports the use of up to four Autodial
numbers per handset. Autodial numbers may be programmed into
handset key sequences
FCN +4, FCN +5, FCN +9, and FCN +*, which
correspond to Fujitsu Feature Access Buttons FAB10 through FAB13
respectively, as shown on the DT14DS key-map diagram.
Programming an Autodial number into the handset will not
program
the same number into the corresponding key on a desk set because
each device is associated with a unique prime line.
Do the following steps to set an Autodial number in the handset. Each
number may have up to 30 digits. All actions are done on the handset.
1. Go off-hook by pressing
START.
2. Go into Program Mode by pressing the key sequence that
corresponds to the Feature Access Button for Program Mode (e.g.
LINE+8).
3. Press the key sequence that you want to program (e.g
., FCN+4).
4. Enter the telephone number (station line or outside number) to be
Autodialed when you press the handset key sequence.
5. Exit Program Mode by pressing the same key sequence that you
pressed in step b above (e.g.
LINE+8).
6. Press
END.