Franklin RF-1064 PDAs & Smartphones User Manual


 
17
Replacing the Batteries
This organizer uses two CR2025, 3-volt lithium batteries.
Before you follow these steps you should have a small
Phillips screwdriver and the new batteries at hand.
Warning! When no batteries are installed, this organizer
will save your information for only about 30 seconds. So
quickly install the new batteries when you remove the
old ones.
1. Turn off the organizer and turn it over.
2. With the Phillips screwdriver, remove the two
screws at the top of the battery cover and then re-
move the lid.
Do not remove the screws at the sides of the orga-
nizer.
3. Remove the old batteries and quickly replace
them with the new batteries, with their plus (+)
signs facing you.
4. Replace the battery cover.
Warning! If
RESET?
appears when you next turn on
the organizer, do not press ENTER unless you want
to reset the organizer and erase all your information.
Keep Written Copies of Important Data
This organizer stores your information as long as the
batteries supply power.
Warning! If the batteries lose power or are removed,
all your information will be lost. Information can also
be lost or corrupted if you make a mistake while oper-
ating this organizer. Therefore, always keep written
copies of your important information in case it is cor-
rupted or lost.