Filter
Top Products
10
Wind Prediction:
If you have chosen Multiple Run Prediction you will be prompted to
select to use wind correction into you ET or TS predictions:
Predict w/Wind?
PRESS 1=Y 2=N
If you enable wind correction you will be prompted to select a vehicle
type:
Select Car Type
Dragster=1
Door =2
Roadster=3
Next you can adjust the wind effect.
Adjust Effect?
Press 1=Y 2=N
Wind factors have been programmed to correct prediction for wind based
on speed and direction of wind. You can further adjust the amount of
correction by selecting to Adjust Effect:
Enter Value
Default (5)
(1-10)=
Selecting <5 means you are lessening and >5 increasing the wind
correction.
The information in this box is only relevant if your unit is OXYGEN SENSOR
equipped.
After pressing the ENTER key (from above) the following will be displayed:
PREDICT WITH
DENSITY ALT = 1
OXYGEN ALT = 2
PRESS 1 or 2
If your unit has the optional oxygen sensor you can choose to predict your ET or TS
value with density altitude or oxygen altitude.
The unit will compute and store the density altitude and oxygen altitude after every
sample. This means that when you add a run to your data base, the unit will
automatically store both altitudes.
This enables you switch between predicting with either altitude and seeing how your
stored runs compared with each.