Filter
Top Products
11
REMOTE OPERATION
Remote Security Code
There is a three digit security code
located on the bottom of your unit.
Remember this number. You will need
it to get your messages by remote when
calling from a touch-tone phone. A
space has been provided on the
enclosed Quick Reference Card to write
down your code.
Remote Turn On
If you forget to turn on your unit, you
can call and remotely turn it on.
1.Call your phone number from a touch-
tone phone.
2. The unit will answer after 9 to 10
rings, automatically turn on and play
your outgoing message.
3. All subsequent calls will be answered.
Messages Playback
1. Call your phone number from a touch
tone phone.
2. Your unit will answer and play the
outgoing announcement. Then you will
hear a beep to signal that it is ready to
record an incoming message.
3. Within ten seconds of the beep tone
dial your 3 digit security code by
pressing and holding each digit for 1
second.
4. Your unit will emit 4 short beep tones
once correct code is detected and play-
back all incoming messages. After the
last message your unit will emit 4 short
beep tones.
5. To repeat the remote message play-
back, dial your 3 digit security code
again within 10 seconds of the last 4
beep tones.
6. To end the remote message playback,
hang up. All messages are automatically
saved and your unit will reset itself to
answer the next incoming call.
Remote Message Erase
1. After listening to your messages, the
unit will emit 4 short beep tones, pause
for 10 seconds and emit one beep tone.
2. Immediately after this single beep
tone, dial your 3 digit security code,
pressing and holding each digit for one
full second.
3. Your unit will emit 4 short beep tones
and disconnect the line. All messages
will be automatically erased and your
system will reset itself to answer the
next incoming call
To Retrieve Messages When
Recording Memory is Full
1. When maximum digital recording
memory is reached, the unit will answer
with 3 beep tones on the 10th ring.
2. Within 10 seconds after the beep
tones, dial your 3 digit security code.
3. Your unit will emit 4 short beep tones
once correct code is detected and play-
back all incoming messages.
IMPORTANT
Remote messages retrieval will not
work when calling in from a rotary
or pushbutton pulse dialing phone
unless a tone generator is used.
Also, some tone dialing phones
(cellular, PBX, etc.) Only output
tones for a fraction of a second. If
you experience difficulty with remote
operation, try another phone, or use
a separate tone generator.