Filter
Top Products
MISCELLANEOUS
51
power is turned on. This number indicates such things as frequency
band, power output, and tier of the transceiver. The eighth digit is
reserved and always “0”.
NO ACCES - Indicates that the radio system could not be accessed,
perhaps because of an out-of-range condition. Refer to “Operation
At Extended Range” on page 54 for more information.
NO PHONE - Indicates that there is no telephone group
programmed in the current system when the Telephone option
switch is pressed (see page 41).
NO POWER - Indicates that the transmitter temperature or supply
voltage is excessive and that the transmitter has been automatically
shut down. Release the PTT switch and allow the transmitter to cool.
If the problem persists, contact your system operator for service.
NOT AUTH - Indicates that an attempt was made to register on a
site where service was not authorized (see page 43).
NOT CONV - Indicates that an attempt was made to enable a
conventional mode feature on an LTR-Net or LTR system.
NOT LNET - Indicates that an attempt was made to enable an LTR-
Net mode feature on an LTR or conventional system.
OUT-LOCK - Indicates that the synthesizer is unlocked. Refer to
“Transceiver Service” on page 55 for more information.
PROG ERR - Indicates an EEPROM read error. Refer to “Trans-
ceiver Service” on page 55 for more information.
SLEEPING - Indicates that the transceiver has been temporarily
disabled by the system operator. It will be automatically enabled
again when operation can be resumed.
SQUELCH - Indicates that the conventional squelch adjust mode is
selected (see page 18).