Filter
Top Products
TELEPHONE CALLS
29
not indicate that the radio system has been successfully
accessed.
5. When the call is complete, place the microphone back on-hook.
Receiving a Standard Group Call
1. Select or scan the system and group programmed for the call you
want to receive (see page 35 for scan information).
2. When the message is received, the display usually changes to the
system and group of the call. Take the microphone off-hook and
press the PTT switch to talk and release it to listen. If scanning, a
response may not automatically occur on the group of the call.
Refer to “Transmitting In The Scan Mode” on page 39 for more
information.
TELEPHONE CALLS
General
NOTE: Telephone calls can be placed and received only if that
service is available to you and your transceiver has been
programmed appropriately. In addition, a microphone equipped with
a telephone keypad is required to dial the telephone number.
The telephone calling feature allows you to place and receive
telephone calls using your transceiver. The following information
describes how these calls are made with LTR-Net and LTR opera-
tion. If you can make telephone calls with conventional operation,
the procedure may be somewhat different and your system operator
will then provide additional information. Proceed as follows:
Placing Telephone Calls
1. Turn transceiver power on and set the volume as described starting
on page 15. Select the group programmed for telephone calls. To