Filter
Top Products
SYSTEM AND GROUP SCANNING
38
LTR and Conventional Mode Scanning
When an LTR or conventional system is selected with system
scanning enabled and roaming disabled, scanning is sequential
through only the LTR and conventional systems in the scan list
(LTR-Net systems are not scanned). If roaming is enabled, all three
system types are scanned as described in the preceding LTR-Net
description. Therefore, LTR and conventional systems are not
scanned while on LTR-Net site.
Scan List Programming
General
NOTE: The selected (displayed) system and group are always
scanned even if they have been deleted from the scan list.
The system and group scan lists are programmed using the A/D
(add/delete) option switch. Pressing this switch changes the status of
either the displayed system or group, depending on whether the
system or group select mode is active. This is the same select mode
used for system and group selection as described on page 17. For
example, to change the scan list status of the displayed system, press
the Select switch if necessary so that the system select mode is indi-
cated and then press the A/D switch.
The displayed system is in the scan list and scanned normally
when is displayed. Likewise, the displayed group is in the scan list
and scanned normally when is displayed (see preceding illustra-
tion). Deleting a system only temporarily deletes the groups associ-
ated with that system. When a system is added back into the scan list,
the original group scan list is again active.
Systems and groups can be deleted from the scan list while
listening to a message on the system or group by pressing the A/D
switch in the normal manner. Scanning resumes shortly after the
system or group is deleted. Scan list programming is not available if
the A/D switch is not programmed.