Filter
Top Products
DTI 2000 Manual e EDITED.doc 12
2000 is recommended, because this is the only way to gain access to the total amount of 100 call
numbers (accordingly to 100 paging console keys).
Connect a DPC 4550 + DPC 4530 to the corresponding input at the DPM 4000 in the PC Designer
Software, give it a meaningful name (e.g. telephone interface), and open the paging console dialog
with a double-click on the paging console icon.
The paging console dialog allows assigning one of the following functions per each call number (0 ...
99) respectively for each entry in the table:
1. Disabled:
The call number #nn has no function.
2. Stop:
Stops the actually active audio signals (chime, text message playback, alarm) depending on the
programmed stop function and priority.
3. Clear:
Clears the actual zone or group selection.
4. Select:
This function selects a zone, group (groups may include up to 100 zones) or all zones (collective
call) for an announcement or text message playback.
5. Text:
This function starts text message playback in permanently pre-selected zones or groups or in the
actual zone selection. Assigning priorities is possible.
6. Talk:
This function starts an announcement in selected zones or groups. It also provides the possibility
to initiate a collective call in all zones. A permanently assigned zone or group as well as the actual
zone selection can be defined as a target. Assigning priorities as well as programming a pre-chime
signal is possible.
A special entry in the table is reserved for the standard talk function (corresponds to the talk
button #108) , which can be activated from a telephone set using the asterisk key (*).
7. Macro:
This function starts a macro via its pre-defined macro number, which of course is only possible
when a corresponding macro has been programmed in the DPM 4000.
A typical call number table might look like that:
Phone No. /
Tone Dial
Code
Function Parameters Priority Remarks
1 (or 01) SELECTION Zone 1 0 Selects Zone 1
2 (or 02 SELECTION Zone 2 0 Selects Zone 2
3 (or 03) SELECTION Zone 5 0 Selects Zone 5
… … … … …
9 (or 09) SELECTION Group 2 0 Selects group 2
10 SELECTION Group 5 0 Selects group 5
11 SELECTION ALL groups 0 Selects all zones / groups
… … … … …
30 EMPTY 0 0 No function
… … … … …
49 EMPTY 0 0 No function
50 TEXT Group 3, Text 2 4 Starts text No. 2 in group 3 with priority 4
… … … … …
59 TEXT All groups, Text 3 7 Starts text No. 3 in all zones with priority 7